CHRO-MA High Stetic Composite System Smile Designers ® Sry 4gm

Call for Price

The highly esthetic composite for direct restorations in the anterior region comparable performance with IPS Empress Direct from Vivadent, Dental Composites are available in the Dental Miami Online store! Check out various Composite Adhesive bonding materials available For performing multiple dental procedures, we offer restoration composites manufactured by top brands! Check out our top-quality flowable composites today! here. 


High aesthetic restorations filling teeth cavities 


Crystalline and Fumed Silicon dioxide 



Photo Initiators 





Since cleaning and etching may cause distinct changes in the natural color of the tooth the selection of the appropriate color should be done before cleaning and etching the tooth

Perform prophylaxis upon surface enamel to be etched, using water and pumice. You should use a prophylactic paste that contains no acid or fluorides. The soft portions of dentine and all decay should be removed. Isolate the tooth with a rubber dam or a roll of cotton. Put a protective base of zinc phosphate or calcium hydroxide.  

Cavity preparation 

Prepare the cavity to remove caries. If liners are required composite filling material is compatible with calcium hydroxide and zinc phosphate cement. Etch the enamel surface in the applied layer of bonding before the application of the composite.  

Etching tooth surface enamel: 

Apply etchant over the tooth’s surface enamel using a cotton pellet or brush. Allow remaining for 20-30 seconds. On primary tooth high in fluoride, 90-120 seconds. If a glass ionomer base is used do not etch for more than 20-30 seconds. A flush area completely for 20 seconds. Do not allow the patient to rinse the mouth or permit saliva to touch the etched enamel surface. 

Air dry completely with an oil/ moisture-free air source. The surface of the tooth should have a dull, white, frosted appearance. If not, repeat the process allowing the etchant to remain on the tooth for an additional 20-30 seconds. 


Apply a thin uniform coating of bonding resin immediately onto the etched tooth surface. Then the resin coating on the tooth with a gentle stream of oil/moisture-free air.  Avoid contact with gingival or other soft tissue. 


Withdraw a suitable quantity of composite; apply the composite in layers of no more than 2mm thick. To thicken and cure the composite exposure to a visible light source, continue this procedure until desired thickness is obtained, ensure that each layer is cured separately, and expose the total restoration to a further 60 seconds of light. High-intensity light will require less time to cure the material so you should test to find the exposure time suitable for your type of light. 


A smooth surface can be obtained by using strip aluminum oxide paper and disc ranging from coarse to super fine. You can polish using the conventional method for acrylics. 


The etching solution contains a 37% phosphoric acid solution, which can be harmful to the skin and eyes. In case of contact, rinse the eyes or skin immediately in plenty of water and seek medical assistance for appropriate treatment. 


-Do not leave at the reach of children

In case of any change in the original function of the product, stop using it and contact the manufacturer. 

For professional dental use only. 

Additional information


WX-Body & Dentin, WX -Dentin, WX-ENAMEL, A1-ENAMEL, A2-ENAMEL


Smile Designers


There are no reviews yet.

Be the first to review “CHRO-MA High Stetic Composite System Smile Designers ® Sry 4gm”

Your email address will not be published. Required fields are marked *

Shopping cart0
There are no products in the cart!
Continue shopping
Wishlist 0
Continue Shopping View Wishlist